DWP-101 Digital Indicator User’s Manual Version 2011 www.digiweighusa.com
9 NAME/CODE DESCRIPTION CODE/VALUE A1 Baud Rate Selects the baud rate for data transmission through the serial port. 1200
10 NAME/CODE DESCRIPTION CODE/VALUE A6 Serial Port Mode Select the mode of the RS-232 serial port;
11 Calibration The indicator is calibrated by following the procedures embedded in H16 (Zero) and H1
12 8. Repeat 2-4 using different test weight value and End C3 then revert to H17. 9. If the calibration was successful, revert to H17. 10. If the ca
13 Key-in span calibration value Note: This procedure is intended for emergency use only in the case of non-volatile memory loss. A v
14 Operation Display Display Details Keyboard Units – This key toggles the indicator among the a
15 Tare -This key is used to establish a Tare provided the following conditions are met: 1 The indicator is not at or below Gross zero. 2 The sc
16 Appendix A Error information: display mode description □□□□□□ weighing mode overload or without ADC input ERR0 H17 Span Calib. The calibration
1 Front and back view of the indicator Front: Back:
2 Connections Connection with Weigh Platform The indicators mounted in an ABS enclosure ship with a 15
3 Configuration The indicator contains two main setup menus: The Setup (“H”) menu, which configures the in
4 Setup Menu Chart The User (“A”) menu sub-menus appear when scrolling left or right from the “H” menu. Some selections shown are not available
5 Use the directional keys to move around in the User Menu Chart. 1. To move to a new “A” heading, use the TARE (left) or PRINT (right) key to move
6 NAME/CODE DESCRIPTION CODE/VALUE H1 Graduation Specifies number of full-scale graduations. Value should be consistent with legal require
7 NAME/CODE DESCRIPTION CODE/VALUE H9 Display Divisions Determines the desired weight increments. Value should be consist
8 User Menu Descriptions This section provides more detailed descriptions of the selections found in the User Menu Chart. Factory-set defa
Comments to this Manuals